Customer Reviews for VEVOR Welding Cart, 2-Tier 4 Drawers Welder Cart with 265 LBS Weight Capacity, 360° Swivel Wheels, Tank Storage Safety Chains, Heavy Duty Rolling MIG Welder Cart for Mig Welder and Plasma Cutter

We are using the cart for a diagnostics set up and its perfect. The drawers are nice for the small attachments and manuals and it holds the size tank we wanted to use. There is a place for the hoses to stay stored. It does take some work to put together but its a great value.

The cart's ok for the price; obviously you're not paying top-tier price nor getting a top-tier product. It goes together well, everything including drawers fit together as they were intended. I have a 200A unimig MIG welder, going by the published dimensions it should have been fine but it just barely fits on top of this cart. The gas line is a little squished and I had to add some rubber underneath to stop the welder feet sliding off the lip of the top tray. I'm also a little nervous re. weight load: there's no way this thing could carry the rated 100kg around. The front castors are also pretty poor, will probably end up replacing those. I'd happily pay a little more for better quality, but that's a hard sell to most people I guess.

After it finally arrived the cart was very easy to build. All the parts fit very well and it is very sturdy

Excellent cart. Exactly what I needed to get my tig welder up and off the floor. Also love the fact it has a place for consumables.

Nice product instructions aren't real well can't tighten everything up until 75% of it is put together but all in all for the price it was nice

It works quality could be better

Nice heavy guage parts and excellent fitment in assembly.

I will admit it was a lot more difficult to assemble than I thought it would be

Took about 45 minutes to put together with a couple mistakes made along the way. The drawers feel better than I thought they would. They can fit smaller reels of wire but, not the big ones. Does fit my stick welding lead in one of the drawers so I always have that with. Only issue is that the Lincoln 210 MP kinda fits in the welder area but, it would’ve been a pain to open the side door without sliding the welder up and back so, I set it on a couple chunks of a pallet and strapped it down to make sure it can’t fall off. The entire cart is a little shorter than I expected. I’m 6 foot 2 and have to bend over to grab the handle to move the thing around. I don’t make a living welding, I just do heavy diesel repairs and whatnot outa my garage so, it’ll get used maybe a couple times a month. Not super often so, I doubt I’ll have any durability issues for quite some time. I don’t think I’d get this for heavy daily use, it is sturdy but, the metal could be heavier duty. The front spinning casters don’t seem great but, neither is my garage floor. I greased all the drawer bearings and casters during assembly. Drawers feel surprisingly good. They are ball bearing drawers. Pretty cheap looking ball bearing setup but, ball bearing none the less. I’ll update if I have any major issues.

I’m using this for my nitrogen bottle for automotive tires in my personal garage so it won’t see a lot of actual rolling around use. Installation: 1) keep most of the bolts loose during assembly. I found that the drawer ms did not align well until I loosened up some bolts then it was perfect. 2) directions are complete and easy to follow. The pictures are helpful 3) the turning wheels do not rotate directionally easily while turning but easy to still maneuver. Again, for general shop tanks, it’s a solid buy.