Customer Reviews for VEVOR Torque Screwdriver, 1/4" Drive Screwdriver Torque Wrench, Torque Screwdriver Electrician 10-50 in/lbs Torque Range Accurate to ±5%, 1/4 to 1/2 Conversion Head with Bits & Case

The screwdriver torque wrench torque settings are approximately 12% off what my calibrated torque wrenches are above 30 in. lbs. It's not bad for what I use it for though. Seems to be well made and it didnt cost $200.00+ dollars.

Used for mounting a rifle scope. Worked well.

Seems to be a clone of the Vortex screwdriver. Worked well for mounting optics. Haven’t calibrated it yet so not sure how accurate the torque is but it seems to feel correct

Very nice inch pound screwdriver torque set. I used it to torque my scope rings.

Torque screwdriver is built sturdy and of a good heft for setting torque on delicate instruments. Bits are easy to change, and has 1/4 inch drive socket to add extension or (included) tee handle.

It is Made in China. The instructions are very poor English and difficult to read. It only has a one year warranty that might only be good in China, but hard to say due to poor English. But it is simple enough to figure out without instructions. It does not have a calibration certificate, but I suspect that is fine for my use. I will use it for DIY electrical work. NEC now requires a torque tool for all screw connections as improperly torqued connections have resulted in fires. I don't know how many electricians are actually using a torque tool. But using any tool is a huge improvement over the past. Only time will tell how well this tool holds up.

The choices in this market space are very limited and can be very expensive. The Vevor seems to be a great balance, I checked it against my larger torque wrench and it seems close to spot on. Vevor is making big gains in the work tool space,

Beautiful tool well made

Using this for mounting optics and doing maintenance on firearms. It is astonishing to me how many people will try to tighten something by feel and then complain when it strips or comes loose. I am very satisfied that this purchase has helped me properly mount and maintain my firearms and optics mounts and even other tools to match manufacturer's specifications. Consider purchasing the right tool, and don't just rely on guesswork and Loctite!

Did the job and it was easy to configure and use. When done and screw driver doesn’t fully reset to zero but seems ok