Customer Reviews for VEVOR Propane Forge Farrier Forge Triple Burner Tool Knife Making Blacksmithing

This easy to use furnace is working great. It will certainly improve my knife building capabilities.

This forge design is better than my previous ones. The burners' placement is close enough to each other to eliminate that \"cold\" spot in between them, making it that much more efficient. The refractory material would have been easier to install with rigidizer, which is not provided with this specific kit. However, it does the job just fine, and there is more than enough refractory material to line the forge. I recommend mixing no more than 2/3 of the bag for the initial coating, leaving you enough for later touch-ups. My main concern is the refractory brick length: one 9\" brick and one half (4.5\"), while the forge floor measures about 15.5\". Therefore, you are left with 2\" of lost floor space to support longer pieces. I wish Vevor would provide the full 9\" along with a 6.5\" second fire brick to close that gap. Otherwise, it is a well-designed, good-quality little forge with good burners. For the price point, you can't go wrong.

I had been eyeing forges on Amazon for a while but just didn't see anything I wanted, then trolling on Vevor I noticed that they carried forges and after reading the reviews from others and watching some YouTube videos about this particular forge I pulled the trigger and purchased it. The forge came extremely well packaged, the overall construction of it is exceptional given the low price. There's not a lot of features you can expect since it's basically just 3 propane flame throwers and a metal tube. This forge is perfect for someone wanting to get started in blacksmithing or knifemaking, bit small for doing any farrier work but perfect for most anything else. Downside to this design is that both ends are open, a door or doors for each end would be good but using the included fire bricks it's possible to seal the openings up for the most part. Very pleased and definitely getting a lot of use from this. As far as being easy to use, once you have it all setup it's great, but the problem I had initially was spreading the refractory cement over the wool on the inside... but I accomplished it by mixing it a little bit thinner and starting from the middle working out to each end, 12 hours later I was forging a couple of coat hooks.

quality forge. Great heat retention. fairly easy to use, just takes some time to get settings dialed in for best results

The gas regulator did not fit a standard Australian LPG cylinder. They were not interested I'd this problem. Customer service was bad

Great heat and size! Consider upgrading regulator if using more than two hours, tank may freeze up on you.

Works great! Just always run both burners at the same time or the heat will travel up the burner that is off and melt the tubing.

While the instructions could use a little more clarifications, the forge performed as expected. I was pleased with the results. Additional recommendation would be to mention that this cannot be used with a standard 20 lb propane tank without an adapter. Already placed another order for additional equipment and looking forward to using it as well.

I haven't had a chance to use them yet, as I have been stuck for time. Having said that, the packaging was good/ arrived in great condition, but going by the initial picture, it is a little smaller than what I was expecting, but I am still impressed with how compact it is. Looking forward to firing it up soon.

Great little forge, easy to assemble, does a great job of smallish tasks for Knife making. hasn't seen a lot of work yet, so not certain how much Gas it goes through.