Customer Reviews for VEVOR Press and Pull Sleeve Kit Bush Bearing Removal Kit 27PCS 45# Steel & Case

I think if you grease these spindles well the tool should last. Unfortunately the tool set was too large scale for my 1994 SAAB 900 Classic rear suspension project. I made the mistake of thinking that there were so many sleeves included that one would surely fit, but they did not. There also have to be duplicate sleeve sizes for the tool to work properly, so it just didn't have as many options as I thought which was my fault. If you're in a similar project situation as me, try using a 3 finger puller tool instead. Clamp your suspension piece in a vice, attach the three fingers to the underside of the bushing housing of the piece you're trying to remove, and use a socket wrench or impact driver to push the bushing out of its housing by twisting the central bolt down. Those popped all of my bushings out cleanly and really quickly. You can pick those up for really cheap, they're lightweight, and they don't take up much storage room.

Boy a usarlas por primera vez y espero den un buen resultado por que la calidad es genial entonces confío en hacer un muy buen trabajo con estos equipos

I struggled at first because I was using the wrong sizes on both sides. I was cranking on it and surely would of snapped. I stopped and got the correct size for the rear so it would sit parallel. After switching the receiver it still was stuck. I wanted to use a cheater bar but I knew it would obviously snap so I down sized the pushing sleeve and it worked flawlessly. I didn’t realize the housing had a taper so the first sleeve was good for about 1/8 inch till it tapered and then it was no longer small enough and got stuck. Almost broke it due to user error.

This tool worked great I ordered a sub frame for my car and it came with the wrong bushings I got the push and pull tool and took old out and put the new ones in no sweat .....highly recommend....thanks guys

Great product has everything you need to do the job. Well presented and very fast delivery time. Will buy again.

Replaced engine mounts on 1990 VW Cabriolet , was easy. Had to use shop press to put new engine mounts in. Highly recommended.

Good quality, this saved me hundreds of dollars, local automotive store were asking 6-7 times the value of this kit for very similar products with a very similar quality. This kit did the job removed old and inserted new bushes in my cars front control arms, easy to use highly recommended.

Very good set. Did everything I needed them to do. Case stays shut and holds everything secured. Has plenty of different sizes and work good in my home shop.

Used this set to remove and fit bearings from the front wheels of a Toyota Camry. Made an angled adaptor plate to get a straight pull from the undercar side on the bearings to remove them. Used a heavy flat steel plate to pull against when inserting. Worked well.

I use this for refrigerator to pump the water from the gallon fast