Marine carpet for boats, yet there are almost no reviews and no pictures at all of this carpet actually installed in a boat. So here is a picture of my boat with the carpet installed! This is NOT glued on; rather, I am using stainless steel snap on fasteners. The \"male\" side has a threaded screw that was already in my boat for the original rug (the far more expensive Sunbrella Syntec stuff). Therefore, it was relatively easy to cut the new carpet to fit various sections of the boat. I used a black majic marker to \"paint\" the top of the male snap fastener and pressed the rug into the fastener to transfer the mark to the back of the rug (rubber part). I also used small strips of plastic over the rug to fit between the upper female and lower male fasteners for extra reinforcement. You can see this in the picture. The manufacturer recommends using glue to install the rug, but who wants to apply glue to the entire floor of your boat?