Customer Reviews for VEVOR Lower Bearing Carrier Puller Propeller Bearing Puller W/ Adjustable Arms

Used to pull worn carrier bearings off a Dana 80 diff. One bearing required the largest breaker-bar I owned and 2 people to hold the differential, but the tool held up great and manged to pop the bearing off without showing any signs of distress. I definitely recommend this for pulling these larger bearings.

This tool does a great job removing the lower bearing carrier larger outboard engines. My outboard has been in fresh water only, which makes this job much easier than salt water units. My tool arrived in great condition, no machining problems, all threaded parts move easy, and true. This brand must inspect their products before shipping, 5 star

Like it found no problem and a very good price.

This puller removed these Chrysler 8.25 carrier bearing easily and intact!

If you planning on doing diff rebuilds this tool will save you a lot of grief, time and money, nothing worse than having to remove new bearings only to destroy them when backlash needs tweaking. Definitely a must have tool, should have bought the kit that comes in a plastic carry case the kit I purchased cardboard box hard to store when not in use. Awesome tool

Worked as intended. Prongs are reversible. Great value compared to other manufacturer.

Used to using a bearing separator and a press, but new shop no press. This is super slick and took care of dana 60 (super duty front and a rear for a jeep) sterling 10.25 and 10.5, ford 7.5 & 8.8, gm 10 and 12 bolt. Make sure you get the 3 ring setup, the 2 ring for $10 less is stupid and could leave you high and dry on bigger bearings. Works prefect, even with shims between carrier and bearing, some people just don't know what their doing. There's actually 4 different sizes by installing the middle sized ring "upside down". for $100 it saves ALOT of aggravation for the professional and also the weekend guy.

This is a well designed kit, I only had to cut the top nut down by 1/2” to fit in my snap on box while standing upright. Also, it says Dana 80, but the pinion is just slightly bigger than the OD of the tool, so while it’s great to pull the carrier bearings off a D80, it doesn’t have enough internal diameter to fit the slightly larger Dana 80 pinion diameter. You’ll still have to cut off/air chisel the pinion bearing on the big stuff, but everything else is mint!

Pretty good for the price///////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////