Customer Reviews for VEVOR Liner Puller Cylinder Liner Puller Dry and Wet for 75-138 mm Diesel Engine

Producto de excelente calidad, es tal cual como se presenta en la imagen, cumple con su función, empaque y tiempo de entrega es excelente

Worked great good tool great price have used the tool two time in the last week easy to used would order again

Used this on my Allis Chalmers I-40 to remove the cylinder liners. I had to remove some material from the pulling disc with a flappy wheel on my angle grinder to make it fit. Let's face it, if you need this tool to remove cylinder liners every day, than this is not for you. It's very cheaply built, the bearing on top is very low quality, you must grease it and crimp the bearing case to the bearings or they will fall out. Mine stayed together for removal of all 4 liners. The 2 support pipes are made of tin foil, but they work. I will probably only use this tool 1 more time in my life, and it is available for my friends to use, so they do not have to buy it. I gave this tool a good review, because it did what it was supposed to, and it did not break, "yet"! I have a pic of tool in use, but it would not let me load it?

Great tool works fine.................................................................................

Bearing are cheap and will fail but it pulled my farmall m sleeves out only issue washad to break sleeves as the were longer than the tool was high. I pulled sleeves until max height of tool the just broke sleeves with hammer and kept pulling.

Great tool. Did what it was made for. I would recommend it .,... ......................,............

Worked perfectly on the sleeves I was pulling. Lube the provided bearing and go to work

I used this to pull the sleeves on a JD350 dozer engine, same as a perkins 3.152. It accomplished the task, but i had to use a hammer to hit the tightening handle. when trying to turn the handle by hand the shaft would just turn from the force required.

The puller works well and suits many jobs

Worked well you my have to sand/grind the edges smooth to fit the cylinder walls. The price was right for a one time use.