Customer Reviews for VEVOR YP-9 Manual Bench Top Compact Bender Pipe Bending Machine 7 Dies 2.5-7.6cmMetal Fabrication Tube Rod Pipe Bender 44ft Mount Powdercoat Telescoping Handle Maximum 5/8 Thick 2.5-38/41cm Width

Perfect. My hubby is making VW Racks and this is what he needed

Man! This tool is fun! broke 3 pipe benders from home depot, they all broke after the 1st or 2nd use, exactly at the same spot. The new pipe bender 3/8 to 1 inch is incomparably better, stronger and it does not flatten the tubes while bending. But be ready, it weighs a ton! No wonder the wooden crate in which it traveled arrives in pieces. It really did not matter, the tool will need a much rougher treatment to start being just scratched... I totally recommend it, by far the best tool for the money!

I've used this bender for several projects and am very happy with the results. It was clean and ready to use upon removing its packaging. It wasn't oily and/or dirty like a lot imported metal working tools are.

If you want a good laugh, check out the instructions in the attached photo! Really? These are close to the worst I have seen.There is a design flaw in this in that the pipe achor (hole that the pipe runs through) is too far away from the mandrel so the first 40 degrees or so of the bend actually come out uncurved and straight. I couldn't figure out a workaround for that problem.

This product is fairly straight forward and simple to set up and use. I see many future uses at the Boat Yard.

Great quality tool. Came in good, sturdy shipping as well.

Recommended for small tubes . Ease of use and setup is a breeze I am very satisfied with my purchase from Vevor delivery went good and on time. Still using it will give another review as I build go kart and mini bike frames.

Muy bueno lo recomiendo

The bender works great. The only issue i had was the jigs are set for a certain diameter for the inside of the pipe not the outside of the pipe. The pipe I needed to bend was considered 1” diameter but the actual diameter of the outside pipe was 1 1/4” and the pipe would not fit in the bender jig. My 3/4” pipe fit perfect on the 1” bender.

I have used other tube Benders and I wasn't sure how this would work, but I have bent stainless in 20mm and it works very well, without any heat or internal sand. The tube bends very well and does not flatten, so this is a good unit. Its solidly built with some weight, but I like that as it feels very sturdy to use and all parts fit snugly. Reg Errol