Customer Reviews for VEVOR Carrier & Pinion Bearing Puller, Compatible with Dana 30, 40, 60, 70, Ford 9\" Bearings, Pinion Puller Tool with 2 Clamshells, 45# Steel Clamshell Carrier Bearing Puller for Auto Repair

Much faster than a common bearing splitter and more consistent undamaged removal of bearings. Does everything the Purple bear units do at a more affordable price.

High quality tool. Very heavy duty. Highly recommended.

Very well made, very beefy, this should last me a long time. It used to be a huge pain pulling bearings but now it just takes seconds. Well worth the investment. From my understanding, durasolid makes all of these bearing pullers and other companies buy it then rebrand it with their name on it. It's VERY common in the tool world, this is no different, I chose to buy from the source and am very pleased. Highly recommend it. definitely recommend using an impact, just make sure to lube the threads.

I was a skeptic. I pressed and pulled a bearing a few dozen times to check for damage. Could not find anything other than the actual contact patch. Measured the cage after each pull, no noticable warpage, no race marring.

Ive pulled quite a few bearings with this since I’ve had it and it’s shown no signs of wear. Just make sure you grease the threads, as with any tool like this. I use it with an impact also.

Works as well as the $400 name brand version for a fraction of the cost. Removes carrier and pinion bearings in minutes with minimal hassle.

i had broken a bearing splitter and a cheap bearing puller before deciding to spend the $ on this tool, my biggest regret is not buying it first. even if you only use it on one set of axles, it is worth the money. it is so fast and easy to use it is almost annoying. and remember, instead of nearly damaging your bearings and races, freeze the races and heat the bearings for a quick and painless install.

I use this to pull the bearing carrier on a mercury bravo one drive. This tool is very well-made and very solid. It seems like it will last a long time and I would recommend it to anyone who needs a tool like this to buy it, it’s money well spent.

These pullers make life easier but I could not justify the expensive brand one. Glad I bought this as it’s the most affordable one out there and I am not disappointed with the quality. Every part seems well made and finished - the clamshells seem strong and offer a number of bearing diameters to choose from. This is the one to consider if you need this type of bearing puller.

I was skeptical of this style tool before purchasing since it doesnt pull the bearing off the inner race which is recommended. Instead this tool requires a bearing race to sandwich the tool within the clamshells. In other words the tool clamshell pulls up on the bearing cage which pulls up on the bearings rollers which then cannot move because you securely sandwiched the race over them. I dont like that but it does work, but know this going in. I used this tool on a small GM 7.5 10 bolt from an S10 pickup. It required the smallest set of clamshells. Any bearing smaller then this bearing may not work with this tool but you can go alot bigger so it should do most any larger axle without issue. It worked and was worth the price for me.