Okay, so first off, this table is heavy! That is a good thing. I assembled using the included instructions and that went well, no issues there. It stands up and collapses easily. I only have a couple of non-positive comments, first, the hardware, why phillips head screws and nuts with now lock washers. Would be better to have bolts with lock washers that allow a better contact surface to firmly/securely tighten the hardware. Also, the four bolts that secure the legs at the pivot point do not have any way to lock them in. Should have a nylon locking nuts on these points since you can't lock them down with lock washers since it is a pivot point. So I imagine opening and closing the legs will loosen the nuts constantly. I will be replacing all of the hardware and adding nylon locking nuts to these pivot points. I said a couple of issues, here is my second, minor issue, the handle. The holes for the handle are 3/8", the handle itself is 1/4 rod bent and threaded. Sloppy. Now I have to bend and thread a piece of 3/8 rod to have a proper handle. Otherwise, this table is heavy and should handle anything I plan to use it for, just hobby welder, not professional.
PacoPR 
