Customer Reviews for Pneumatic Car Jack 6600lbs Heavy Duty Air Jack Lifting Height Up To 16''

Worked well on my 1-ton truck was easy to use easy to move around but a little bit unstable when fully extended. So I would recommend putting a block beneath it if you must raise an extended distance

I have a 1973 GMC motorhome, 24' model that weighs around 10,000 lbs. I am renovating the motorhome front to back, bottom to top. I purchased the Vevor pneumatic car jack to lift the motorhome so I could put it up on jack stands and work safely and comfortably underneath. The jack easily lifted the entire front end as well as each rear set of tires. This jack is similar to rescue air bags that firefighters use as well as airbag suspensions used in custom cars and the jack is just as heavy duty. Yes, it is a bit heavy, but that attests to it's strength and durability. This jack works so well that when I put the coach back on the road the jack will be onboard. I have a compressor already onboard the coach, so it is really a no-brainer.

I had to change the crankshaft sensor on a Express 2500 3/4 ton van. This awesome air jack lifted it quickly And I was done with the job in 15 minutes I love this jack from Vevor. It’s the best thing since sliced bread!

Works very good. Good price and value.

The best part about this jack is NOT having to pump the handle or twisting the handle to lower the jack. I lifted the left side of a Ford Explorer (~4,000 lbs) easily with about 60 PSI. Unlike a hydraulic jack, the lift was smooth and quick. Having a tow handle makes positioning the jack a snap. The air line connection is the same as all my air tools. The bronze filter fitting on the exhaust side is a thoughtful idea so the user does not get an air blast when lowering the jack. Being able to slowly control the lowering is a major improvement over my hydraulic floor jacks.I always check torque on the fasteners before using the device. A couple of the 16 screws were less than finger tight. I torqued all of them to 150 inch pounds, 4 and 5 mm Allens. I also cut a 4X4 block to sit over the rubber cap for some extra height. Probably won't use it for my Ford Edge.Overall, very pleased with this device.

perfect easy to assembly and is great

Gerät ist voll in ordnung

Easy to assembly but needed to do some prep work. The photo shows the inside of 1/2 of the handle. It has very sharp burs inside. The concern is that these burs would damage the plastic air tubing that is routed inside this handle tubing. I filed the insides of the tube ends so they were smooth before assembly.The handle angle has been a problem is several instances. It is a short handle and the angle is too steep when using the jack on front suspension or in the middle of the rear axle on rear wheel drive cars and trucks.So long as it is used to jack on the frame from the side if the vehicle it works very well.I feel it is worth the money and am hopeful it will hold up over time.

So much safer than a hydraulic jack. Smooth rose and fall. Easy to use. I have a Dodge ram 2500. Worked great! You might need to exchange the air line fitting for a smaller connection.

The idea is great, BUT , who carries an air compressor around in their vehicle?