Customer Reviews for Plasma CutterAir Plasma Cutter Non-touch Pilot Arc Cut-40 Dual Voltage 220V 40A

I hand to change the power supply plug and that's all it needed, works awesome on 5/16 aluminum diamond plate, better than I expected

Works great but beware in setup, the hose clamps it comes with are not great - use better ones.Order extra consumables.When using, take off the spring clip on the ceramic head - the performance goes up 200% but the consumables take a hit.Beware they do have cheaper ones but the duty cycle on this model was double the less expensive one - also DO NOT get the ones without instant start.

Product arrived on time and was packaged well great value with all the parts included ground clamp could stand to be a bit longer but thats easy to correct for my purpose was able to cut 3/8" painted steel with ease i wouldnt hesitate to recommend this to anyone

Shipping was fast and came when it said it would. Unit functions great and cuts steel like butter. Would definitely recommend this unit for hobbyists.JH

It quit after 15 minutes of cutting. It was working very well, just quit. Connections are good and air flow is proper.

Can't get it to work with langmuire table. Hf start interferes with the electronics. Is there a way to change it to blowback start

he loves it he uses it more than anything now for every that deal with cutting metal wise

Everything came as expected. 110VAC/220VAC a little confusing as it came with 110VAC plug only so not sure how to how up to 220VAC?

Unit arrived on time and undamaged. Cutting a lot of 1/4" plate on 220volts and it does a nice job in the hands of this novice. It runs fine on 30A breakers. Some have commented about the ground clamp. I've had no issues with the clamp but the cable pulled out of the male connector on the other end. Set screw was tight but it didn't capture the cable well. I put a 6ga sleeve inside a 4ga sleeve and reinserted the cable. Now the set screw tightly grips the cable. Do not expect any further issues.

It works like expected. It is a great asset to my home shop. I recommened this plasma cutter to other home DIYers. My only concern was there was no expert that could answer my questions about an adequate plug for 220V.