Customer Reviews for Plasma CutterAir Plasma Cutter Non-touch Pilot Arc Cut-40 Dual Voltage 220V 40A

Nice system for the money. Used it hard right out of the box. Did everything I needed. Ran it hard for 3 hrs w/o any issues. Easy set up.

Right out of the box it cuts like butter

Works as it should best thing I have bought in awhile use it almost daily

This plasma cutter is working way better than expected, it's actually well built and does a great job at what it's advertised to do. Highly recommend for anyone looking for a plasma cutter to cut no more than 1/2 steel.

Took a bit to get it to functional status on 120v. Haven’t had the chance fo 240v. Does what it should. Don’t really need to cut more than 3/16” an occasional 1/4”. The regulator has a leak which will get a repair or replacement. From 20 gauge sheet metal to 3/16” mild steel it hasn’t got a problem on 120v, 1/4” not so much.

This is a great device. The instructions are a bit light but its easy to figure out how to set it up and it works better than I expected. I have only used it on 220 volts so I can't comment on how well it will handle 110.

It works as they said, used it to gouge my loader bucket cracks so i could reweld it , worked very well with minim warp age. didn't try the 110 volts, I hooked it to 220 right away. would be nice to have more consumables, and a better book to go with it.

works great easy to set up has everything you need to start cutting

I works great

It worked well,I was quite surprised and satisfied with its performance