Customer Reviews for Plasma CutterAir Plasma Cutter Non-touch Pilot Arc Cut-40 Dual Voltage 220V 40A

I do fab work and have several plamza cutters, this is one of the better one's, cuts 1/4" steel like butter and the consumables are not very expensive, another great vevor product..

This piece of equipment has performed well for me - I have used it in the construction of a shop building to cut 1/4" steel and 1/16" steel. It has proved invaluable.

I can’t compare it to any other brand as this is my first time using it. The 110/220 feature is perfect for my needs. Easy to assemble, light weight. I have only used it a few times but it has done everything I needed done.

Works good. I hate these surveys that demand long answers. Are you listening? I just about clicked off. I'm doing YOU a service.

Bought this small plasma cutter to cut up some scrap steel I have collected and can say it is a great little unit. Setting at 25Amps I cut up the entire F650 cab into manageable pieces all on one electrode and one tip. I have run both industrial wayer cooled plasma units and the name brand air cooled units in the past and can say this is a grcat unit for the home shop. Would I cut 1/2" plate, no but for light stuff this unit is great! I would recomend to run it on 240V like I did. I have a 5 hp air compressor and it was able to keep up Jo problem only running about 1/3 of the time.

For the price I am extremely impressed. Plugged it in, hooked up the air and started cutting. Took just a couple of minutes practice to get the feel for travel speed. Nice LED for amp reading and super easy control knob.

This machine seems to be working fine,it does everything they said it would.which they carried the consumables!

My old plasma cutter gave up so I searched for replacement components. I ended up just buying a new Vevor plasma cutter. It was cheaper then the replacement parts for my Hobart and 1/2 the price. Fast shipping ,good price and works just as good as my old one if not better. Vevor came through again.

Very nice. recommended

It may be hard to believe that this plasma cutter could do anything at this price point. Well, it works perfectly, even if you’re cutting 1/2” thick steel. If you are cutting 1/2” or 3/8” steel you’ll want to plug this into a 220 outlet but if you’re cutting something thinner than that your 110V outlet will work just fine. Hard to find anything wrong with this cutting and nit picking doesn’t feel good….but for those who like it: the ground cable could be a bit longer and the air pressure gauge could read PSI but, if that stops you….you probably should spend several hundreds more on a machine that works no better than this one! It’s a great little machine!