I purchsaed this pump for a 12 foot tilt trailer that had a valve on the ram going port to port a manual setup. I read a lot of reviews and I was worried about a lot of people having problems with trying to find some non standard British fittings. It came in the box with 4 fittings. I removed the ones in the pump replaced them with the other provided. I made two hoses up for exact fit. Everything I used was power steering ram fittings. Welded a piece of flat bar 2"x3/8 8" long to the frame for mounting. I bolted the pre threaded pump block with M10-1.5x35MM to the welded flat bar. The the port coming out of the relay valve with the red knob on it is the pump (up) button and the other side of the block is the the (down). I adjusted the pump so it would not over pressure up or down, so it would bypass at a reasonable pressure. It lifted 2800Lbs with ease. The unit was properly prewired. All of the electrical stud contacts had to be torqued. Be carful the isolated relay contactor is a cheaper one but sufficient for the load. I Used two number 2 wire with no voltage drop at 3' long. Pump is fast. I installed some baffles on the hoses at A-B outputs to tame it down little. I dont think the solenoid and relays are water proof. If this thing will be exposed to weather I would build a cover over the pump electronics. I have only ran it 30-40 times to soon to tell if it will last. Good design well made product for the money. Unit came packaged good.