Customer Reviews for VEVOR 150HP Hydraulic Outboard Steering Kit Boat Marine System, Built-in Two-Way Lock Cylinder, 150HP Pump and High-Strength Nylon Hose for Single Station, Single-Engine use

This has been a great replacement for my old and tired cable steering.The build quality is first rate - I can't imagine anyone being disappointed.Installation was straight forward on a 90HP Mercury SeaPro.However, throw away the destructions, which are virtually unintelligible. My only criticism.Download instructions from other suppliers of more expensive, surprisingly similar products, hint, hint.Photo #3 shows how I routed the hoses into my motor well. Tidy and watertight.I couldn't be happier!

easy to install with some mechanical back ground, hand wife help with bleeding air out of system, turn steering wheel until you get back pressure, then open valve, no different then bleeding brakes on vehicle, its good too have two quarts of Hyd steering oil, catching bleed off oil and refilling fill bottle worked great.

The steering on my Ranger boat seized and ripped apart, so I decided to retrofit it with hydraulic. Vevor was the least expensive option. To remove all of the old system took a long time, considering 30 years of corrosion. To install the new system took maybe 4 hours. I had two minor issues on installation; 1) The arms did not reach far enough to bolt to the cylinder shafts, so I took a 3-pound hammer and bent them further. A $500 kit, so no turning back now. Next, the flare nut that was included had stripped out, so I used the original brass that I had. The strength and quality of the nut it is questionable. Other than that, everything else installed smoothly, and I had it out on the water just a few hours ago.

Study what Rick you were steaks they do not tell you it takes a different bracket to change it fluid very expensive works OK should have bought SeaStar about the same price of the time you’re done

Instructions are bit sketchy,, the unit. Works well, but not one finger steering. A finished plumbing diagram would have been useful. All in all I am satisfied.

Easy to install. For the price it steers my stratos like a dream

Installation was straight forward. No big problems. Hardest part is of course bleeding the system. Once that was done all works well and I have no problem tilting it into the motor well.

Placed on 2005 Nitro 18 ft fiber. 150 mercury. Works great, easy turn. Plenty of videos on net to install.

Easy install and set up. Bleeding took about 15 minutes and then smooth effortless steering. My 2004 merc 4 stroke had become difficult to turn when trimmed all the way down and very difficult when trimmed up. Now I have to look to see if the motor is up or down. Wish I had done this years ago

Quality product