Customer Reviews for VEVOR 10 KG Rotary Welding Positioner Turntable Table, Mini 2.5 Inch 3 Jaw Lathe Chuck with Pedal, Manual 0-90ºWelding Positioner Chuck 2.5" 3 Jaw Lathe Chuck 180mm Portable Welder Positioner

Nice positioner,I added rubber feet, it just needs a larger chuck to come with it!

it is everything I expected

Arrived as stated and is just what we needed. Would recommend this product

This was a Christmas gift for my husband, which he asked for. He absolutely loves it!! Does exactly what its supposed to. It was a great purchase for me!

It is exactly what we expected. It didn’t come with any information for parts and the foot petals cord is too short.

can't be beat for the price, you will need to set it up and adjust the contact under the rotary table but as a hobbies guy I have always wanted one.Made my own isolated ground so attaching the ground on my bench takes a secondI will update after more use if necessary

To reference size in photos, The elbow is 1.25” schedule 10, The tube in the second photo is 1”. It shipped really fast. No damage to the box or product. The machine was broken when I opened it and started to use it. The foot pedal terminal on the machine that you plug the foot pedal into had a bad solder.(not allowing the pedal to work). I fixed it in less than 5 minutes. 2 rpms, the lowest setting I could get it to turn, is well fast enough for tig on a 1” tube. It’s highest speed would equal roughly around a 10” tube. So there is some room in speed adjustment. The foot pedal is not a on/off switch. It’s a momentary switch. You hold down for rotation and let off for stop. Which I find is better than a on/off. In conclusion I would buy this over again. Even with the bad solder I’d buy it again. It rotated fine, handled multiple multiple welds fine, and grounded properly. I just have to get accustomed to letting the machine rotate the work and me not moving. I do wish the ground lead was longer but I can wire that up myself. JUST BUY IT. Again you get what you pay for and it was work the small investment.

It will definitely get you by and easy to to modify to make it what you need it to be or do. I like it, it works for me.

First off, it is a solid device and pretty much does what it's supposed to do. If I were on the design team, these are what I'd modify:* The slowest speed available is almost too fast, and that's for 1 - 2" pipe. Anything larger and the rotational speed would be too fast for TIG welding. At that lowest speed also means the travel is a little inconsistent. I would re-gear it so a workable speed would be somewhere in the halfway range of the motor speed.* I would like to see the motor speed knob in the front, not in the back where I can't see it.* would love to have a morse taper in the center so I can mount my own vice or fixture. As it is, you're pretty much stuck with the default vise or just the table.I've read reviews where the foot switch cable is too short. Not the case with this one. There is more than enough to reach the floor from any height bench.The little vise works well and will handle small work.Regardless of my recommended improvements, I'm glad I got it.

I’ve been a custom fabricator for 35 years, not sure how I did it without this unit. Not sure why any of the negative reviews, this thing exceeded my expectations and saved me so many hours that it paid for itself on the first job. Only downside is I wish I knew what all the automation controls did, there is no manual or instructions to operate it.