12x9inch Tilting Milling Table Angle Plates Milling Machine 40degree Adjustable

This tool did the job after i spent 3hrs reworking it, including machining the base to make it flat and parallel to the table face using my milling machine. I had to make spacers for the worm screw to remove all the slack which otherwise make the tool difficult to use.

I use this to set angle in front of grinder for tool sharpening. works good fast shipping. I use this to set angle in front of grinder for tool sharpening. works good fast shipping.

Quite a good thing. It seems to be well made and should do exactly what I want. It suits the size of my mill and adds versatility.

Seems to be well made except for 2 very small pin holes in the casting on the top face. Had the usual dirt on most import tools but it cleaned up ok. Can't speak to how well it will work because I have not used it yet. Vevor seems like a responsible company shipping was very fast.

Bought this for a friend to use on his horizontal mill. Nice and low profile so he doesn’t give up too much room Doesn’t have super precise measurements, but works great for roughing in his railroad track anvils.

I contacted Vevor before purchasing my 10" x 7" tilting angle plate concerning a review about unfinished saddle surfaces and was assured they have stringent quality controls. When it arrived I was very pleased with the way it was packaged in double boxes with the angle plate oiled and double wrapped in plastic. Top was ground, bottom appeared to be ground, degree increments were clean and concise. For the price I was very happy but I still wanted to check it out further. It was set and locked on o degrees so I placed it on my bench top mill table which was trammed in at .002 for a 7 3/8" circle. The first thing I noticed was it rocked diagonally so I flipped it over on it's top and got the same results. Next I clamped it down on the table and ran the four corners setting the first corner at 0. The remaining four corners were .005" of an inch higher (see pic). Next I noticed the the outer corners of the top saddle were not in contact with the base saddle (see Pic). Finally looking at the saddle surfaces they appear (my opinion) to have been cleaned up with a sanding disc on an angle grinder, the same for the two long sides of the top plate(see Pics). For most of what I do for $104 this will suffice, but for some more precise I wouldn't recommend it. With all that said I'm pleased enough to keep it and possible attempt to bring it in closer latter on. I've been a machinist for 40 years working at McDonnell Douglas and Boeing. Sorry two pics would not load.

Good value for the money and up to the task I bought it for. More toys for the mancave machinist. *******************************************************************************************

https://www.vevor.com.au/rotary-table-c_10128/vevor-178x125mm-tilting-milling-table-angle-plates-clean-precise-milling-machine-p_010571346494 NICE AND COMPACT FOR MY USE.

Very impressed for the price! Surface finish and parallel is good. Backlash on this type of table is acceptable. Recommended! I have a 7x10 and a 5x7. I had a shipping issue (I got a TV stand instead of the 5x7 but after sending pictures it was resolved )

It is of good quality, and easy to use. As a mold maker, I always look for things that would make my life easier. The set up process is fast, and accurate for roughing in parts.